[nos-bbs] SNMP MRTG with JNOS

[Bill Vodall]

I've learned to check and re-check before posting to the sig.  It's
the re-re-check that usually gets me.  Something seemed funny here
where the manual command was working and the mrtg command from the
config file wasn't.  So I re-re-rechecked.   Yup - I goofed...

>> Unfortunately I supported just the parameters required for MRTG, I
>> did not go anywhere as far as supporting full snmp walks, I was just
>> looking at some very basic MRTG stuff.
>
> That's all I'm trying to do here too.

> I'll keep digging.   It's just some little thing.

The SNMP command that worked:

+ snmpget -v1 -c jnos 192.168.27.12 1.3.6.1.2.1.2.2.1.10.2
IF-MIB::ifInOctets.2 = Counter32: 749286

The MRTG comand that didn't...

#Target[192.168.27.115]: 2:jnos at 192.168.1.115:

SNMP was going to JNOS (192.168.27.12) while the MRTG command was
running against the Linux host (192.168.27.115) which had no MIB
enabled to display.   Changing the .115 to .12 and I'm on the air at
last.

Thanks Maiko and everybody else...

>

Sure nice to see some data showing up on the chart.   It's been years and years.

Max Average Current
In 3.0 B/s (2.0%) 4.0 B/s (2.7%) 4.0 B/s (2.7%)
Out 0.0 B/s (0.0%) 0.0 B/s (0.0%) 0.0 B/s (0.0%)

>
>> Maiko
>
> Bill