[aprssig] Argent arduino shield

[Andrew rich]

Thank you for your reply

 

I see the Arduino Mega has more than one UART 

 

So do I have to do anything on RX ?

 

The shield decodes and presnts on pin 1/0 tx/rx of the arduino

 

Does that show up on the serial monitor ?

 

 

Mr Andrew Rich

vk4tec at tech-software.net

vk4tec at internode.on.net

http://www.tech-software.net

0419 738 223

  _____  

From: aprssig [mailto:aprssig-bounces at tapr.org] On Behalf Of Scott Miller
via aprssig
Sent: Tuesday, 14 June 2016 2:25 AM
To: TAPR APRS Mailing List
Subject: Re: [aprssig] Argent arduino shield

 

Yes, it will transmit and receive.  The RX side is a little picky about
signal levels and doesn't have much filtering, so try to give it a clean
signal.

Scott
N1VG

On 6/12/2016 12:24 PM, Andrew rich via aprssig wrote:

Can the argent arduino shield tx and rx ?

 

I see code to tx and rx but can it do it like a tnc ?

 

i guess u could spend most of your time rx unless a tx event is needed ?

 

plan to use the uart on an arduino to talk to shield

 

software serial gps

 

Mr Andrew Rich

vk4tec at tech-software.net

vk4tec at internode.on.net

http://www.tech-software.net

0419 738 223

 






_______________________________________________
aprssig mailing list
aprssig at tapr.org
http://www.tapr.org/mailman/listinfo/aprssig

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20160614/50e843c3/attachment.html>