[nos-bbs] INP3 settings jnos

[Bob Tenty]

Hi Maiko,

Tnx, will do that.

With jnos release (2.0J.3) I see a SABM packet every time before it
makes a L3RTT
transmission to my standard ax25 node in linux. 
Not good!

I made a 45 minute recording of these transmissions at that port and
every time jnos
is doing that.



JNOS to XNET L3RTT transmissions look normal, No SABM frames by jnos
before L3RTT here.
(As far as I can see)

73,

Bob Tenty


On 13-11-05 11:49 AM, Maiko Langelaar wrote:
> Hey Bob,
>
>> Running with your original kludge for the moment.
>
> IF you are running the latest 2.0j.4, then try the following :
>
>    rsync -av www.langelaar.net::jnosX <jnos src directory>
>
> Do a 'make', this will give you a new 'inp ifaces' command, example :
>
>   inp ifaces ax0 xnet2 gus bob hull
>   start inp
>
> Do not configure INP3 ifaces to BPQ or traditional nodes. Perhaps
> others who are well versed in Xnet/FlexNet/INP3 may want to chime
> in on  this, it certainly could use some open discussion I think.
>
> There are some other issues that I need to look at, but the above
> technically replaces the kludge. Use it to configure those ifaces
> on which you want to run INP3 on. You can run 'inp ifaces' anytime
> you want with a new list, doing so replaces the previous list.
>
> I've made note of ALL your observations, and I'll see if I can get
> all of that resolved in the next while. Thanks for that.
>
> Maiko
> _______________________________________________
> nos-bbs mailing list
> nos-bbs at tapr.org
> http://www.tapr.org/mailman/listinfo/nos-bbs

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/nos-bbs_lists.tapr.org/attachments/20131105/f70dbe0d/attachment.html>