[aprssig] It's Baaack BPL - Broadband Over Powerlines
Ev Tupis
w2ev at yahoo.com
Sat Dec 16 05:46:09 EST 2017
In a nutshell, these are simply femto-cells that are linked to eachother via and RF backbone. No reliance on wires at all. The only association that they have to power lines is that they are co-located on utility poles. -Ev
On Friday, December 15, 2017, 8:12:07 PM EST, Gregg Wonderly <gregg at wonderly.org> wrote:
I mean microwave and up high frequencies. It sounds like 60g based on the other reply. If so, then high power wave guide binding to the copper wire would be possible and it would be extremely clean of RFI it would seem.
Gregg
On Dec 15, 2017, at 7:02 PM, noskosteve at yahoo.com wrote:
There's no guarantee that journalist knows that high frequency means HF.
Regards, Steve Noskowicz K9DCI
Science & Technical Advisor
>From my tablet.
-------- Original Message --------
From:Gregg Wonderly
Sent:Fri, 15 Dec 2017 18:50:46 -0600
To:Brian Webster
Cc:aprssig at tapr.org
Subject:Re: [aprssig] It's Baaack BPL - Broadband Over Powerlines
That is not what I see. The first part of the article talks specifically about high frequency signals over copper wire. If they go high enough in frequency, the radiation into the atmosphere will be short lived, and the can use higher voltages to get longer distances. The second part of the article talks about additional work on using RF to the home instead of physical fiber so that they can maintain their work within the right-of-ways and not have to run anything physical to your home, where trees and other debris end up destroying services in weather events.
Gregg
> On Dec 14, 2017, at 11:08 AM, Brian Webster wrote:
>
> This is not BPL, they are just mounting radios above the power space on utility lines. They are not modulating any signals over the power grid.
>
> Thank You,
> Brian N2KGC
>
> -----Original Message-----
> From: aprssig [mailto:aprssig-bounces at tapr.org] On Behalf Of Nick VA3NNW
> Sent: Thursday, December 14, 2017 11:26 AM
> To: aprssig at tapr.org
> Subject: Re: [aprssig] It's Baaack BPL - Broadband Over Powerlines
>
> Stephen H. Smith wrote:
>> [...] AT&T begins testing high-speed internet over power lines [...]
>> >> igh-speed-internet-over-power-lines-idUSKBN1E70GB>
>
> Honestly? Can't kill this zombie? I thought fibre to the home was finally going to put this one to bed - you can push far more bandwidth down a glass pipe than a copper one anyway, with far less interference to OR FROM people like us, emergency services, radio astronomy, etc, not to mention better EMP resiliency.
>
> Perhaps FTTH isn't easy enough to wiretap? :-(
>
> Nick VA3NNW
>
> --
> "Nosey" Nick Waterman, VA3NNW/G7RZQ, K2 #5209.
> use Std::Disclaimer; sig at noseynick.net
> Sauron is alive in Argentina!
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> http://www.tapr.org/mailman/listinfo/aprssig
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> http://www.tapr.org/mailman/listinfo/aprssig
_______________________________________________
aprssig mailing list
aprssig at tapr.org
http://www.tapr.org/mailman/listinfo/aprssig
_______________________________________________
aprssig mailing list
aprssig at tapr.org
http://www.tapr.org/mailman/listinfo/aprssig
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20171216/777da454/attachment.html>
More information about the aprssig
mailing list