[aprssig] kpc-2 audio input level help

[MJ Inabnit]

I really don't know.  This tnc arrived in a box of junk, no manual etc, 
so I don't have any info.  I've googled, but haven't found anything yet. 
   I know the kpc3 had jumpers or pots or something.  But I have what I 
have at this point.

tu om!  73

j

On 07/25/2016 10:15 PM, Eric Lorenz K9LGE wrote:
> I don't know if it's the same in the -2, but in the -3 wasn't there a
> jumper or something that you could insert/remove to change the output
> level? Wondering if that might be in the -2 also...
>
> Eric
>
>
> On Jul 25, 2016 14:07, "MJ Inabnit via aprssig" <aprssig at tapr.org
> <mailto:aprssig at tapr.org>> wrote:
>
>
>     Hi Gang:
>
>     Have two tnc's here, one is pk12 running wonderfully.  My problem is
>     my KPC-2.  It works only on some signals.  I have it wired for my
>     ft-8900 to its acc port so I can still use the other band for day to
>     day vhf/uhf ops when not using the tnc.
>
>     Is there ANY way to tweak the audio line level from the 8900 just a
>     bit so it can copy slightly less deviated signals?   I have only the
>     downloaded op manual which sort of covers the KPC1 all the way
>     through the Kam and KPC-4, but doesn't show anything at all about
>     adjusting input/output levels.
>
>     I'm hoping maybe a pot or a resister value might be changed or
>     something.
>
>     As for the 8900, there doesn't seem to be any level adjustments for
>     the acc port audio.
>
>     thank you,
>
>     73
>     j
>
>     --
>
>     wishing you well
>     Jaye, ke6sls--via the toshiba w/thunderchicken3
>     _______________________________________________
>     aprssig mailing list
>     aprssig at tapr.org <mailto:aprssig at tapr.org>
>     http://www.tapr.org/mailman/listinfo/aprssig
>


-- 

wishing you well
Jaye, ke6sls--via the toshiba w/thunderchicken3