[aprssig] program for linix
Lee Bengston
lee.bengston at gmail.com
Tue May 27 17:32:01 EDT 2014
I tried something out. On a Raspberry Pi with aprx and ldsped running, I
never saw ldsped go above 2.3% cpu utilization with both YAAC and APRSIS32
communicating with it from another computer on the network. APRX is so
small and light that it is not even showing up on the list when I run top.
The thing I like most about using ldsped as opposed to server ports is that
it provides an AGW port that carries RF packets only.
Lee - K5DAT
On Fri, May 23, 2014 at 7:59 PM, Max Harper <kg4pid at yahoo.com> wrote:
> Thanks, I'm going to check that out. I found out that I could in fact
> connect to Xastir's server port using UIView32 and YAAC. However it sent
> the CPU usage through the roof.
>
> On a RaspberryPi with APRX and Xastir
> load average: 0.15, 0.19, 0.22
> With the, server port enabled and UIView and YAAC connected.
> load average: 0.94, 1.09, 1.05
>
> Hopefully ldsped will run much better.
>
> Thanks again, Max KG4PID
> *From:* Lee Bengston <lee.bengston at gmail.com>
> *To:* TAPR APRS Mailing List <aprssig at tapr.org>
> *Sent:* Friday, May 23, 2014 8:36 AM
>
> *Subject:* Re: [aprssig] program for linix
>
> On 22/05/14 16:04, Max Harper wrote:
>
> Does the server port only work with xastir or is it compatible with
> other aprs programs such as UIView32. I wish there was a server port
> built-in to the AX.25 stack in Linux that looked just like the APRS-IS,
> then any computer on the network could use it.
>
> The closest thing is ldsped, which will provide access to the AX25
> network via 1 or more agwpe compatible interfaces. For example, an old
> computer or Raspberry Pi running LInux can be connected to a TNC and set up
> with AX25 networking and run a headless Igate such as aprx along with
> ldsped. UIView or APRSIS32 could be running on a separate Windows computer
> on the same network and access the TNC via AGW interfaces. Most APRS
> clients support AGW interfaces, so this setup does enable any computer on
> the network to access the RF from a single TNC/radio combo.
>
> Lee - K5DAT
>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> http://www.tapr.org/mailman/listinfo/aprssig
>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> http://www.tapr.org/mailman/listinfo/aprssig
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20140527/f267cbe6/attachment.html>
More information about the aprssig
mailing list