[aprssig] Opentracker Help Needed

[Andrew Rich]

Ah good point !

I have a Targus PA088 USB to SERIAL

I also have a desktop PC here with a serial port I will try that

Thanks for the heads up !


-----------------------------------------
Andrew Rich - VK4TEC
vk4tec at tech-software.net
www.tech-software.net
Brisbane AUSTRALIA

  -----Original Message-----
  From: aprssig-bounces at lists.tapr.org
[mailto:aprssig-bounces at lists.tapr.org]On Behalf Of scott at opentrac.org
  Sent: Tuesday, 20 December 2005 1:19 AM
  To: 'TAPR APRS Mailing List'
  Subject: RE: [aprssig] Opentracker Help Needed


  Hi Andrew,

  There are a few USB adapters out there that have trouble with the
OpenTracker.  This seems to be due to the fact that the turnaround between
RX and TX is too slow to respond to the bootloader's startup signal in time.
What model USB adapter are you using, and do you have a standard serial port
to test with?

  Scott
  N1VG



----------------------------------------------------------------------------
    From: aprssig-bounces at lists.tapr.org
[mailto:aprssig-bounces at lists.tapr.org] On Behalf Of Andrew Rich
    Sent: Monday, December 19, 2005 2:21 AM
    To: TAPR List
    Subject: [aprssig] Opentracker Help Needed


    Gudday

    Got one of Scott's opentracker kits on the bench.

    Volts are good, I know the data is going back and forth from the chip, I
see data on the CRO.

    I have a USB to serial adaptor with LED's on it and I can see the PC
transmitting towards the kit when the config program is running.

    When I power cycle the kit in the connect mode, sometimes the KIT LED
comes on, showing config mode, but then nothing happens.

    I know there is data coming from the chip as well, cause when I power
cycle it, I can see the RX LED in the USB / COM port adaptor flash.

    Are there any data speeds or stop bits that need to be set ?

    I have tried jumper 2 and jumper 3 (config select in and out) same deal.

    Ideas ?


    -----------------------------------------
    Andrew Rich - VK4TEC
    vk4tec at tech-software.net
    www.tech-software.net
    Brisbane AUSTRALIA

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20051220/fffabf71/attachment.html>