<div dir="ltr">I observed an interesting effect that I wanted to share. I noticed that when I listened to my VLF audio stream that during local thunderstorms with local lightning, power line hum levels would be much louder. I thought this was an effect of the mains tracking filter under overloading by local sferics, but it turns out, it's the VLF receiver.<br><br>I'm guessing that when the VLF receiver is overloaded (whether the front end, line driver, isolation transformer, or all three), harmonic levels increase drastically. This can be seen in an amplitude plot of the 180 Hz harmonic, showing that drastic increase exactly at the time of local lightning:<br><img src="cid:ii_lgu8bndm0" alt="Screen Shot 2023-04-23 at 3.15.56 PM.png" width="542" height="171"><br><br>Here is a closer look:<br><img src="cid:ii_lgu8cdhm1" alt="Screen Shot 2023-04-23 at 10.17.10 PM.png" width="542" height="179"><br><br>This coincides with increased sferic activity shown in the noise level of the sferics band, 5-7 kHz:<div><img src="cid:ii_lgu8dasj2" alt="Screen Shot 2023-04-23 at 3.17.57 PM.png" width="542" height="170"><br><br>Here, shown in increased time resolution:<br><img src="cid:ii_lgu8e6cc3" alt="Screen Shot 2023-04-23 at 10.20.56 PM.png" width="542" height="172"><br><br>I wanted to note too, that the data going into vtsid to create these plots is *before* the mains tracking filter, so this effect is definitely due to the VLF receiver. In my conversations with Paul, the author of vlfrx-tools, he mentioned strong signals can overload the isolation transformers and create lots of harmonics, so I'm guessing this is what is happening here, increasing the levels of mains harmonics (so much that I can hear them clearly, too). Anyone else have any ideas?<br><br>In any case, I thought this was pretty interesting to report.<br><br>Jonathan<br></div><div>KC3EEY</div></div>