<div dir="ltr">Scotty,<br><div><br></div><div>Looking at your schematic, the resistor on the address line for the MCP9808 is on the high side.  There no resistors on the lo-side of the de-selected addresses.  This bothered me when I was making the prototypes, and I put them on the ground side, because the Adafruit breakout board does it that way.  The Microchip spec sheet does not specify, as far as I can tell (see attached).</div><div><br></div><div>In practice, it did not seem to matter much for me.  I forgot them altogether at first and they still let me select addresses reliably.  But perhaps at the cost of extra current drain or something.</div><div><br></div><div><br></div><div>Dave</div></div>