<div dir="ltr"><div dir="ltr"><div><br>Notes from PSWS / TangerineSDR call of 12-09-2019</div><div><br></div><div>1. Do we want to change the jumper reference ID to JPxx ?  This may get tricky because two of them are dual purpose (filter power connector for one use, ground jumper for a different use). To save space do we want 2mm connectors instead of 0.1 inch? Tom: There is a strong likelihood that folks will accidentally try to put (existing) 0.1 inch jumpers onto a 2mm pin header causing damage.</div><div><br></div><div>2. Scotty will provide comments on the receiver schematic, and we will roll another revision by next week. Will add a cover sheet (specified by Scotty) with specific information.</div><div><br></div><div>3. Discussion on bias-Tees.  If we want to maintain higher common mode isolation, the bias-T should isolate both the center conductor and the ground lead of the feedline. This is not how most bias-Tees are built, so we may want something special.</div><div><br></div><div>-- Tom, N5EG</div><div><br></div><div><br></div></div></div>