<div dir="ltr"><div dir="ltr"><div>The Interface Control Document for the receiver RXM-5001D has been updated to account</div><div>for the how the data pins and I2C, SPI pins are actually wired rather than how we guessed they</div><div>might be wired. It's close. The I2C and SPI addresses have been updated to how the</div><div> schematic is actually drawn.</div><div><br></div><div>The ADC and ADC-driver devices have been selected and the datasheet URL references</div><div>changed accordingly.</div><div><br></div><div>The specification document also needs to be updated.  The ICD is higher priority so</div><div>Scotty can check the changes made. Spec changes later....</div><div><br></div><div>The 1-dB step attenuators have been changed to a 10-db fixed and a 20-db fixed attenuator.</div><div>Neither, one, or both can be selected to give 0, 10, 20, or 30 dB attenuation. </div><div>There are separate attenuators for the two channels.</div><div><br></div><div>Care has been taken to isolate the receiver grounds to provide common mode rejection without</div><div>the need for an external choke or transformer.  Zero-ohm resistors may be installed to bond the</div><div>grounds together if needed.</div><div><br></div><div>TSDR_RXM_5001D_ICD_TangerineSDR_RF_Module_V0.2.pdf</div><div><br></div><div>-- Tom, N5EG</div><div><br></div><div><br></div></div></div>