<div dir="ltr"><div>I have uploaded Version 0.1 of the Interface Control Document (ICD) for</div><div>the RXM-5001D receiver.  That's the two-channel 14-bit receiver planned</div><div>for use in the PSWS project.</div><div><br></div><div>The connector has been changed from M.2 to MEC5 Right Angle 140 pin per</div><div>Scotty's recommendation.  Even this is very short of pins needed.  To </div><div>accommodate necessary slow-speed I/O I2C is used.  This will also allow</div><div>other module types to have GPIO expandability in the future via I2C.</div><div><br></div><div>Scotty has in parallel been working on the ICD for the Data Engine, since the</div><div>two connectors have to match.</div><div><br></div><div>TSDR_RXM_5001D_ICD_TangerineSDR_RF_Module_V0.1</div><div><br></div><div>-- Tom, N5EG</div><div><br></div></div>