<div dir="ltr">Good afternoon everyone,<div><br></div><div>   I recently purchased the Raspi 20M WSPR board and over the past weekend put it on a raspi.  I followed the instructions on the tapr website for installation and put on Wsprrypi following the guide.  When I run the command line in the document, it says it is transmitting but listening on the frequency I hear nothing.  I tried putting a power meter in 5 watt mode to see if the needle would even move and no luck.</div><div><br></div><div>I am not quite sure how to debug and wondering if anyone can point me in the correct directions.</div><div><br></div><div>Thank you!<br clear="all"><div><br></div>-- <br><div class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><br><div><br></div><div>Mike Myers</div><div><a href="mailto:netnutmike@gmail.com" target="_blank">netnutmike@gmail.com</a></div><div>K3DO</div><div><br></div><div><a href="http://mikemyers.me" target="_blank">http://mikemyers.me</a></div></div></div></div></div></div></div></div></div>
</div></div>