[hfsig] TAPR 20M WSPR Board/Raspberry Pi 3
Merv Thomas
vk6bmt at iinet.net.au
Mon Jan 7 21:24:40 EST 2019
Hi,
I just acquired the 20M board and set it up to transmit into my Magnetic
Loop (tuned accurately to the WSPR transmit frequency of 14.097100).
I have run this unit for many hours without anyone receiving my
signals. Measured output on my power meter shows 90 mW and on my
spectrum analyzer the signal looks very clean and shows with around
100mW output.
Measured frequency of transmissions are up to 200Hz different to what is
being shown on the WSPR data screen in my Win10 PC - could this be the
reason no one decodes my transmissions?
If I use my Yaesu FT-450 throttled down to as low as I can get it
(150mW) into my loop antenna I get numerous received reports so it seems
the loop antenna is not the problem. Using WSPR Ver 2.0_r174.
I'm new to the forum so hope I do not breach any of the rules!!
73,
Merv VK6BMT
More information about the hfsig
mailing list