<html>
<head>
<meta http-equiv="Content-Type" content="text/html; charset=UTF-8">
</head>
<body>
<div class="moz-cite-prefix"><br>
Ironically perhaps, I did a test just yesterday with a Part 15
LoRaWAN GPS<br>
tracker on the Helium network. Helium is relatively low-cost to
use, I bought<br>
credits for 2,000,000 reports for $20. This experiment definitely
gives some<br>
context to the discussion of Part 15 vs Part 97 in a practical
way.<br>
<br>
My tracker in this case was near the maximum Part 15 power
(+30dBm)<br>
with a small mag-mount antenna on my car (no more than +6dBi). I
was<br>
running DR0 (SF10BW125) for the sake of testing; further testing
will be at<br>
higher data rates that don't offer as much processing gain (and
don't<br>
run into the 400mS dwell-time limitation).<br>
<br>
I drove from Fairfield, CA to Bodega Bay (Fishetarian lunch, yo).
While I<br>
haven't done a detailed analysis, initial mapping shows I was
almost<br>
always in coverage except for the very rural section of Sonoma
county <br>
between Valley Ford and Bodega Bay (mostly cattle out there).<br>
<br>
Map of location pings:<br>
<br>
<img src="cid:part1.qp005cF8.E0wQ4flw@comcast.net" alt=""><br>
<br>
If you're interested in further information, please email me.<br>
<br>
73,<br>
Dana K6JQ<br>
<br>
<br>
On 8/8/2022 10:50 AM, Scott Howard wrote:<br>
</div>
<blockquote type="cite"
cite="mid:CAAv8cyxWjKp3T8G7992ud0RV9tV=Cc_8O=wO5HvUVGS7WvYuAw@mail.gmail.com">
<blockquote type="cite">
<pre class="moz-quote-pre" wrap="">Is there a document somewhere that walks through the spread spectrum
rules and documents if LoRa counts as SS under Part 97 and if so (or if
not) how it meets the rules? I really have no clue about this and would
like to read about it; I do remember somebody getting an STA but they
were using a 50W amp and the STA might have been for higher power?
</pre>
</blockquote>
<pre class="moz-quote-pre" wrap="">
Here's a talk about the 50W amp with LoRa you mentioned (Dan Fay,
KG5VBY, at DCC). The link below will bring you right to the part of
hte talk where he discusses the Part 97 regulations and his STA
(0721-EX-ST-2018).
<a class="moz-txt-link-freetext" href="https://youtu.be/AAo2r3mGsBM?t=1024">https://youtu.be/AAo2r3mGsBM?t=1024</a>
Outside of Part 97, this is a summary of the Part 15 rules (for
completeness): LoRa is typically used as unlicensed ISM (Part 15
instead of Part 97) which allows for SS emission. LoRa typically is in
bands around 433 MHz or 900 MHz. In the US, the 900 MHz band (more
precisely, 902-928 MHz) is an unlicensed band that allows for SS
emission at higher powers that the unlicensed 433 MHz band, and the
900 MHz band also allows for optional frequency hopping SS to achieve
even higher powers.
The FCC rules (15.247):
<a class="moz-txt-link-freetext" href="https://www.ecfr.gov/current/title-47/chapter-I/subchapter-A/part-15/subpart-C/subject-group-ECFR2f2e5828339709e/section-15.247">https://www.ecfr.gov/current/title-47/chapter-I/subchapter-A/part-15/subpart-C/subject-group-ECFR2f2e5828339709e/section-15.247</a>
TI has a nice application note (see page 8, "Transmit Power Limits for
the 902–928 MHz Band")
<a class="moz-txt-link-freetext" href="https://www.ti.com/lit/an/swra048/swra048.pdf">https://www.ti.com/lit/an/swra048/swra048.pdf</a>
Quick summary (for mostly isotropic antennas with gain < 6dBi)
- If the channel bandwidth is between 25-250 kHz: Power limit
(delivered to antenna) is +30 dBm. Total dwell time at a specific
frequency cannot exceed 0.4s in a 20s period (i.e., you have to hop to
50 different frequencies within 20s if continuously transmitting)
- If the channel bandwidth is between 250-500 kHz: Power limit is +24
dBm. Total dwell time at a specific frequency cannot exceed 0.4 s in a
10s period (i.e.,you have to hop to 25 different frequencies within
10s if continuously transmitting)
So you can avoid worrying about frequency hopping by designing the
system to transmit short messages at low frequency, which fits nicely
with APRS.
_____
Scott Howard, PhD
Associate Professor
Department of Electrical Engineering
College of Engineering Bioengineering Program
University of Notre Dame
<a class="moz-txt-link-freetext" href="http://ee.nd.edu">http://ee.nd.edu</a>
574-631-2570 (direct)
574-631-4393 (fax)
<a class="moz-txt-link-freetext" href="https://howardphotonics.nd.edu">https://howardphotonics.nd.edu</a>
Follow me on Twitter @HowardPhotonics
262 Fitzpatrick Hall
Notre Dame, IN 46556
_______________________________________________
aprssig mailing list
<a class="moz-txt-link-abbreviated" href="mailto:aprssig@lists.tapr.org">aprssig@lists.tapr.org</a>
<a class="moz-txt-link-freetext" href="http://lists.tapr.org/mailman/listinfo/aprssig_lists.tapr.org">http://lists.tapr.org/mailman/listinfo/aprssig_lists.tapr.org</a>
</pre>
</blockquote>
<br>
</body>
</html>