<html><head></head><body><div style="color:#000; background-color:#fff; font-family:Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif;font-size:24px"><div id="yui_3_16_0_ym19_1_1518301907065_5593">Hi</div><div id="yui_3_16_0_ym19_1_1518301907065_5593"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">look for the best way to interface the Kantronix 3 plus to Motorola CDM 1550.</div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">it would seem that for RX audio it would be best is to use the flat output on the 20 pin connector and remover the EQ jumper in the Kantronix 3 plus. Is this correct?</div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">For the TX audio i am unsure if the EQ jumper then makes the output of the Kantronix 3 plus flat or not. Thus should i use the flat input on the 20 pin connector pin 5 or the mike input 20 pin connector pin 5?</div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">Any other advice on settings greatly appreciated.</div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">Thank you in advance for any help.</div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr"><br></div><div id="yui_3_16_0_ym19_1_1518301907065_5593" dir="ltr">Chris</div></div></body></html>