<div dir="auto">I have experienced so much grief from NiCd batteries over the years, I will never use them again if I can help it. I got a real nice screw gun a couple years ago for Christmas that has NiCd batteries. Every time I go to use it, the batteries are dead and I have to wait a couple hours to charge one. I have a small electric screwdriver with lithium batteries that was in storage for almost a year. When I unpacked it, I used it heavily for a week before I had to charge it. It held its charge all that time in storage. When I can, I'm going to have my remaining NiCd packs converted to lithium cells.<div dir="auto"><br></div><div dir="auto">Michael WA7SKG </div><div dir="auto"><br></div></div><div class="gmail_extra"><br><div class="gmail_quote">On Jul 14, 2017 16:14, "Robert Bruninga" <<a href="mailto:bruninga@usna.edu">bruninga@usna.edu</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div lang="EN-US" link="#0563C1" vlink="#954F72"><div class="m_-8764603695728902173WordSection1"><p class="MsoNormal">Lesson relearned on NiCd charging:  Several years ago I made three 12v batteries from D cell NiCd’s.</p><p class="MsoNormal"> </p><p class="MsoNormal">They have been a huge disappointment.  They are only used once or twice a year on critical field work and always fail far earlier than estimates.  But I always just charge them the night before with a fixed voltage charge of 14 volts since I most often forget about batteries I put on charge and end up ruining most of them.  Charging at fixed voltage is safe…</p><p class="MsoNormal"> </p><p class="MsoNormal">For the AT Golden Packet event tomorrow, last night I left them on my usual 14 volt overnight charge and they were “fully charged” by morning, only drawing a 50 mAh each in the morning at 14 volts..</p><p class="MsoNormal"> </p><p class="MsoNormal">Put them on a battery analyzer and their capacities came in at 10%, 8% and 3%.  Then the battery analyzer quick charged them at 1C rate for 1 hour with them getting up to 16 or 18 volts, then a 4 hour equalization charge of 0.1C or 400 mA.  </p><p class="MsoNormal"> </p><p class="MsoNormal">Then it retested them and got 75%, 65% and 85% of rated capacity!</p><p class="MsoNormal"> </p><p class="MsoNormal">So, Apparently little-used NiCd’s are not going to get a good charge from a FIXED voltage charge!</p><p class="MsoNormal"> </p><p class="MsoNormal">Wish I had time to cycle them two more times.  On batteries at work we see huge recoveries from little used NiCd’s when “rejuvenated” which is the 3 cycles of charge and discharge I started with above.</p><p class="MsoNormal"> </p><p class="MsoNormal">Bob</p></div></div>
<br>______________________________<wbr>_________________<br>
aprssig mailing list<br>
<a href="mailto:aprssig@tapr.org">aprssig@tapr.org</a><br>
<a href="http://www.tapr.org/mailman/listinfo/aprssig" rel="noreferrer" target="_blank">http://www.tapr.org/mailman/<wbr>listinfo/aprssig</a><br>
<br></blockquote></div></div>