<div dir="ltr">On Fri, Mar 10, 2017 at 10:51 AM, Mark Conner <span dir="ltr"><<a href="mailto:mconner1@gmail.com" target="_blank">mconner1@gmail.com</a>></span> <wbr>wrote:<br><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">I think I can do that with the TNC-Pi and aprx, but haven't looked that hard on how to do it yet.</div></blockquote><div class="gmail_extra"><br></div><div class="gmail_extra">Yep. RF-gating a specific near-by weather station which happens to be Internet-only is common. All you need to do is configure your APRS-IS login to include a b filter to include the desired weather station's callsign in your APRS-IS feed, then include the same filter again down in the APRS-IS source block of your digipeater config to drive its packets to RF.</div><div class="gmail_extra"><br></div><div class="gmail_extra">As for the overall objective of RF-gating weather stations, as long as you're only doing it for the nearest weather station and not something like every weather station in the county, it's a very reasonable objective to put useful information on your local RF LAN.</div><div class="gmail_extra"><br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">From: spam8mybrain <<a href="mailto:spam8mybrain@yahoo.com" target="_blank">spam8mybrain@yahoo.com</a>><br>However, it did bring up another related question: can weather be reported as APRS Objects rather than as station position reports? This would make sense if the weather sensors were not co-located with the radio station, but were a distance away sufficiently large that assuming co-location would introduce noticeable error.</blockquote><div class="gmail_extra"><br></div><div class="gmail_extra">I wouldn't work that hard at it. Callsign-SSIDs are cheap, so if the weather telemetry is coming from sensors not close enough to your APRS node to beacon the weather info directly, make a new virtual callsign-SSID with the correct location and maybe gate it third-party to RF.</div><div class="gmail_extra"><br></div><div class="gmail_extra">If the sensors are so far from your APRS node that the readings aren't representative of where your APRS node is, it might not be of value to RF-gate them locally anyways.</div><div class="gmail_extra"><br clear="all"><div><div class="m_-2943278333527504864gmail_signature">--<br>Kenneth Finnegan, W6KWF<br><a href="http://blog.thelifeofkenneth.com/" target="_blank">http://blog.thelifeofkenneth.<wbr>com/</a></div></div>
<div class="gmail_quote"><br></div></div></div>