<html>
<body>
<blockquote type=cite class=cite cite=""><font size=3>On 26 Feb 2014, at
8:09 am, Tony VE6MVP
<<a href="mailto:tony@ve6mvp.com">tony@ve6mvp.com</a>>
wrote:<br><br>
<blockquote type=cite class=cite cite="">At 01:44 PM 2014-02-24, Andrew
Rich wrote:<br>
</font><blockquote type=cite class=cite cite="">
<font face="Arial, Helvetica" size=2 color="#000080">Found it <br>
<br>
+ The radio body port is for freq etc<br>
+ The head port is for TNC </font></blockquote><font size=3><br>
No, it's not that simple. The radio body com port is for updating
the radio body firmware and the memory. The head com port is
for updating the control head firmware, TNC settings, and current A and B
side radio settings including frequency, offset and tone.
And, of course, send and receiving data packets..<br><br>
Tony </font></blockquote></blockquote><br>
<font size=3>At 02:21 PM 2014-02-25, Andrew Rich wrote:<br>
<blockquote type=cite class=cite cite="">That's odd <br><br>
I can not get the d710 to do any command other than tnc via the head
<br><br>
Also d710 group confirms d710 freq is set via
body</font></blockquote><br>
No the D710 group did not confirm that the active D710 freq is set via
body. There's a difference between updating the
frequencies in the memories in the body and updating the settings visible
on the control head.<br><br>
<blockquote type=cite class=cite cite=""><font size=3>What is freq
command ? Read or set </blockquote><br>
</font>Read the PDF file written by Kai. It's kind of hard to
figure it all out and I haven't spent the time myself on it that I would
have like to <font size=3>I would continue this discussion in
the D710 group as that is much more on topic.<br><br>
Tony</font></body>
</html>