<html>
<head>
<style>
.hmmessage P
{
margin:0px;
padding:0px
}
body.hmmessage
{
font-size: 10pt;
font-family:Verdana
}
</style>
</head>
<body class='hmmessage'>
Hi folks,<br><br>I have a low-level RF->internet APRS gateway set up in the shack.  I'd like to enable the Internet->RF side, and would like some guidance for the correct settings.  I'm currently running Xastir 1.8.4 (yes, it's old) on an old SuSE 10.0 Linux box, connected to an MFJ-1278T TNC and an Alinco DJ-580 HT (5 watts Tx power available).<br><br>It's low level because the antenna is simply a twin-lead J-pole hanging on the wall (about 10' above ground level, at the top), and our house is in a bit of a hole, being by a creek.  Initially I set it up just to receive APRS information from RF and display what was going on in the area, weather reports, etc.  Then when we got an always-on internet connection, I enabled the RF->internet gateway.<br><br>Recently I've been contacted a few times by folks for whom I Igated their APRS signal into the internet.  Low-level or not, it's providing a service.  One person noted that I appeared to have the transmit side disabled; he was trying to do some bi-directional messaging, and wasn't having any success.  I'd kind of like to try that too, so I need to turn on the Transmit side.<br><br>On the Xastir interface control properties page, I see the button to allow transmitting, and the RF->Inet and Inet->RF button.  Currently I have Transmit disabled, and the RF->Inet only button selected.  Path 1 is set to APX184 via WIDE1-1; paths 2 and 3 are blank.<br><br>Obviously I need to enable Transmit, and the Inet->RF buttons.  But, what do I put for the Igate -> RF path?<br><br>Are there any other settings I should be aware of before enabling Transmit?<br><br>Thanks!<br><br>Greg  KO6TH<br><br><br /><hr />Rediscover HotmailŪ: Now available on your iPhone or BlackBerry <a href='http://windowslive.com/RediscoverHotmail?ocid=TXT_TAGLM_WL_HM_Rediscover_Mobile1_042009' target='_new'>Check it out.</a></body>
</html>