[aprssig] Fwd: APRS Meteor test (TX list)?
spam8mybrain
spam8mybrain at yahoo.com
Mon Nov 16 21:21:09 EST 2020
Ok, I'm ready to smoke the airwaves. I couldn't seem to work out the timing for continuous status packets, but I am sending out 57 of them in 15 seconds, starting 15 seconds after the top of the minute. Not sure if the default DireWolf TXDELAY is long enough for the 2m linear.
My SWR meter is showing 1:1.8 (150 watts out and 10 watts reflected back).I can still local stations even behind my beam (via digis to the side), so I don't think my 3 element beam is that directional, but it's pointing about 270 degrees (West).Are we sure we want to clog the airwaves with this tonight?Andrew, KA2DDOusing the alias METEOR-2 from EPA section
-------- Original message --------
From: Robert Bruninga <bruninga at usna.edu>
Date: 11/16/20 10:27 (GMT-05:00)
To: Tyler Griffiths <tyler.griffiths at gmail.com>
Cc: spam8mybrain <spam8mybrain at yahoo.com>, TAPR APRS Mailing List <aprssig at lists.tapr.org>
Subject: Re: [aprssig] Fwd: APRS Meteor test (TX list)?
The few METEOR-X stations will be transmitting on normal 144.39 from midnight to about 6 AM tonightAll you have to do is check your heard list tomorrow morning and see if you got wny.bobOn Sun, Nov 15, 2020 at 4:08 PM Tyler Griffiths <tyler.griffiths at gmail.com> wrote:What frequency should we be listening to?Tyler GriffithsN7UWXSee where I am:bit.ly/2v2tOoROn Sun, Nov 15, 2020 at 10:28 AM spam8mybrain via aprssig <aprssig at lists.tapr.org> wrote:I'm trying to get YAAC reworked for bursting. As to actually running a beam-antenna transmitter, I was going to climb on the roof to rig it today, but if no one is going to listen, not sure if there's a point in doing so.WA8LMF said he had a turn-key UIview setup.Andrew, KA2DDO-------- Original message --------From: Robert Bruninga <bruninga at usna.edu> Date: 11/15/20 12:02 (GMT-05:00) To: TAPR APRS Mailing List <aprssig at lists.tapr.org> Subject: [aprssig] Fwd: APRS Meteor test (TX list)? Subject: Re: APRS Meteor test (TX list)?To: Marshall-K5QE, Bill Booth <ve3nxk, GEO Badger <w3ab, Andrew Pavlin (YAAC), wa8lmf(UIview)Cc: kd4iz at frawg.org>We have seen only a few volunteer TX stations (mostly from the EME reflector) and I dont think I have cpaatured anyone from AMSAT or APRS that have stepped forward,Biggest problem is lack of a turn key TX program for these non APRS volunteers. No one has said they are ready to TX.Maybe a few of you are working on it, but Im not hearing anything. I'm sorry that I am so poor health I cannot organize it better. Just thought I should summarize the feedback I have gotten.The ADDEE's are high power mostly EME stations. Did anyone see anyone else that responded as if they were working on something?If we dont have a turnkey TX program, I guess we can stand down.Bob-----------------------------To clarify exactly what a high power TX station needs to send is say 30 copies of the APRS grid format in a single burst IE send this to the TNC every minute:>GG##gg<CR>>GG##gg<CR>>GG##gg<CR>>GG##gg<CR>...>GG##gg<CR>>GG##gg<CR> The TNC will concatenate probably seven to ten of these at a timel into dense TX packets with only a single TX delay, not 30 delays. The TNC has UNPROTO set to simply "APRS" no path! And set to CONVErSE..Adjust the number (30?) till the TX burst lasts 15 seconds each minute.The result is 30 complete grids in only 200 milliseconds each. Hopefully short enough so that occasionally one will get bounced somewhere by the extremely short meteor path bursts at VHF. Point beam to a high ham population density at least 600 miles away. Vertical or Horizontal will work.This will take special software for the 15 TX stations. (METEOR-1 through METEOR-15)RX stations need nothing special. Any APRS software should capture and decode and plot a grid report if received overnight. All of this on the national channel 144.39 from midniight to 6 AM local timeHere is the report form 1998 event http://aprs.org/APRS-docs/LEONIDS.TXTBob WB4APR
_______________________________________________
aprssig mailing list
aprssig at lists.tapr.org
http://lists.tapr.org/mailman/listinfo/aprssig_lists.tapr.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20201116/6e090dd3/attachment.html>
More information about the aprssig
mailing list