[aprssig] MFJ Data Radio
Curt Mills
curt.we7u at gmail.com
Wed Mar 16 16:54:52 EDT 2016
Funny. A co-worker of mine 25 years ago bought an MFJ TNC that was a clone
of the TAPR-2 TNC. Same issues: Poor solder joints everywhere. I and
another buddy re-soldered every joint and it worked great for the original
owner after that.
On Wed, Mar 16, 2016 at 1:51 PM, Frank Knobbe via aprssig <aprssig at tapr.org>
wrote:
> On Wed, 2016-03-16 at 12:59 -0500, Al Wolfe via aprssig wrote:
> > Richard et al,
> > This one is on 144.39 so had hoped to use it for APRS. Service
> monitor
> > says transmit power is nearly 5 watts, but on receive it takes a couple
> of
> > microvolts to see anything out of the noise. Maybe I'm expecting too
> much.
>
>
> I have a 8621A. When I first received it, it was near deaf. Or totally
> deaf, don't remember. I had sent it back to MFJ (lazy, no time, was
> brand new and I expected more) and it arrived back on my door step in
> the same deaf condition. So I took a look at it myself.
>
> Basically, the solder job was crap. I resoldered everything. What fixed
> the problem was the solder joints on the crystal itself. Since the
> ground is on large area of copper, that solder joint just needed some
> extra TLC. Once it was soldered properly, the radio worked like a charm.
>
> Take a look at your solder joint, especially in areas where cold joints
> can happen easily. Check the joints of the crystal. (I still recommend
> spending a bit extra time to resolder every joint).
>
> Hope that helps,
> Frank
>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> http://www.tapr.org/mailman/listinfo/aprssig
>
--
Curt, WE7U
http://wetnet.net/~we7u
http://www.sarguydigital.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20160316/b7765cb4/attachment.html>
More information about the aprssig
mailing list