[aprssig] [These] Mobile Digipeating

Tue Sep 20 09:45:45 EDT 2011

Negative, Doc.  See
http://www.arrl.org/news/fcc-clarifies-what-constitutes-an-amateur-radio-repeater

"03/23/2009

'In December 2007, Gary Mitchell, WB6YRU, President of the Northern
California Packet Association (NCPA <http://www.n0ary.org/ncpa/>), filed a
Petition with the FCC, asking for the Commission to clarify the definition
of a repeater. According to Part 97, Section
3(a)(39)<http://edocket.access.gpo.gov/cfr_2002/octqtr/pdf/47cfr97.3.pdf>,
A repeater in the amateur service is "[a]n amateur station that
simultaneously retransmits the transmission of another amateur station on a
different channel or channels."

'Mitchell sought clarification on the word "simultaneously," asking if it
referred to the signal information being retransmitted, or to the fact that
the receiver and transmitter must both be active at the same time while
acting on the same signal information. On March 23, 2009, the Commission
clarified that even if there is a slight delay between what is received and
what it transmits (as in the case of D-STAR and other digital repeaters), it
is considered simultaneous if the receiver and transmitter are both active
at the same time."

Vy 7 3

Earl

KD5XB

On Tue, Sep 20, 2011 at 7:05 AM, Dr. John <w3ate at earthlink.net> wrote:

> **
> Lynn,
> Repeating is repeating either simples or duel.
> The FCC, stated clearly states this.
>  The only unit's that are repeaters and in mobile mode are as example mini
> repeaters in police cars, like the state police used when they enter a
> facility and in remote areas.
> Theses units were made by Midland and some other companies. But they were
> registered.
> John W3ATE-8
>
>  *From:* David Nichols <dnchls at gmail.com>
> *Sent:* Monday, September 19, 2011 10:32 PM
> *To:* 'TAPR APRS Mailing List' <aprssig at tapr.org>
> *Subject:* Re: [aprssig] Mobile Digipeating
>
>  All of this brings up another issue. From the little I’ve been able to
> gather about mobile digipeating, and I agree with the statement below ( I
> believe temporary re-locatable is a better term), it is for temporary
> emergency use. If this is correct, what constitutes “emergency”. Could I
> justify using it as described for practice purposes? I practice, on the
> average, twice a week, for 1-2 hours. I would hate for my next posting to
> you folks to be from Leavenworth after my first digipeating session J. Or
> for that matter, would I be getting nasty-grams from the APRS community?
> Otherwise, I think this might fit my needs. I could also use it on actual
> searches, especially if I drive a ways from Incident Base to the subject’s
> place last seen, which has been the case several times.****
>
> ** **
>
> dave****
>
> N5FMA****
>
> *From:* aprssig-bounces at tapr.org [mailto:aprssig-bounces at tapr.org] *On
> Behalf Of *Jim Alles
> *Sent:* Saturday, September 17, 2011 9:52 AM
> *To:* TAPR APRS Mailing List
> *Subject:* Re: [aprssig] Mobile Digipeating****
>
> ** **
>
> Besides, we really aren't talking about mobile digipeating.  That is not
> recommended for APRS, either.  ****
>
>  ****
>
> I would call it a re-locatable digipeater, others might use the term
> portable.   It is temporary, fixed use.****
>
> Peace,****
>
>  ****
>
> Jim A. KB3TBX****
>
> On Sat, Sep 17, 2011 at 8:53 AM, Lynn W. Deffenbaugh (Mr) <
> ldeffenb at homeside.to> wrote:****
>
> A digipeater is not a dual-frequency repeater, but a receive and
> re-transmit on a single frequency.  There is no pre-registration required in
> the United States that I'm aware of.
>
> Lynn (D) - KJ4ERJ - Author of APRSISCE for Windows Mobile and Win32 ****
>
>
>
> On 9/17/2011 8:32 AM, Dr. John wrote:****
>
> Mobile repeaters in the amateur environment is not authorized. As repeaters
> need to be registered at a fixed position
>
> Dr. John Gregory /W3ATE-8
>
> --------------------------------------------------
> From: "Tom Russo" <russo at bogodyn.org>
> Sent: Saturday, September 17, 2011 1:02 AM
> To: "TAPR APRS Mailing List" <aprssig at tapr.org>
> Subject: Re: [aprssig] Mobile Digipeating****
>
> On Fri, Sep 16, 2011 at 10:34:30PM -0600, we recorded a bogon-computron
> collision of the <dnchls at gmail.com> flavor, containing:****
>
> I am in search and rescue and use APRS so others can keep track of me.****
>
>
> You're in good company.****
>
> I
> live in New Mexico where we have many digipeaters on mountain tops, but we
> still have many dead zones.****
>
>
> I've been watching your tracks.  I'm not sure the dead zones are as dead as
> all that.  Still, there are some notable places where there are searches
> and
> that have spots where you can't be heard.****
>
> I have a YAESU VX-8DR ht that I carry with me
> both when practicing and on actual searches. I am considering buying a
> Kenwood TM-D710A. I would like to use the 710 in my mobile as a digipeater
> to either get back to search base on a search or to a mountain digi when
> I'm
> practicing so my family can know where I'm at on APRS.fi. I would typically
> be within a couple of miles from my truck when I transmitted an APRS signal
> from my ht. How much power does the 710 transmit when in digipeater mode?*
> ***
>
>
> It transmits with the same power that you have set for its own APRS
> transmissions.****
>
> Would this be a situation where using a mobile would be useful? Presently,
> it just doesn't seem I have the punch I need when using the ht.****
>
>
> It would help if your truck is generally within range of your handheld, the
> truck is in a good place where it is getting digipeated, and you don't have
> terrain in between you and the truck that prevents the truck from hearing
> you.
>
> In this case you could use your truck's callsign as the first hop in your
> digi path, and WIDE2-2 next in the path.  That'd let your truck beacon you
> with more ooomph.
>
> The downside of this is that if you wind up in a spot where your truck's
> radio can't hear you, you won't get anywhere even if a WIDE can hear you,
> because they won't premptively digipeat before your truck.
>
> It's unfortunate that Yaesu chose not to implement "Proportional Pathing"
> in the
> VX-8*R series radios.  The VX-8R lets you set 8 paths, but rather than
> cycling through them, it simply concatenates them for every transmission.
> I'm
> unfamiliar with the VX-8DR, maybe it does have proportional pathing.  With
> proportional pathing, you can set multiple digi paths, but rather than
> using
> them all at once, it cycles through them for each transmission.  Then you
> could have "TRUCK,WIDE2-2" for every third transmission,
> "WIDE1-1,WIDE2-2" for every third transmission, and "WIDE2-2" for every
> third.
> That would take care of making sure that at least SOME of your packets get
> to a wide digi --- either directly, or through your truck, or through a
> fill-in.****
>
> Unfortunately, the people I know both in SAR and amateur radio have never
> played with mobile digipeaters and are pretty clueless on the matter.****
>
>
> Clueless?  I don't think that's a fair statement.
>
> To date, most SAR activities in the state have managed without pressing
> need
> for mobile digis.  NM SAR Support's comms trailer does have a TNC
> programmed
> to digi WIDE1-1, so if your path is WIDE1-1, WIDE2-2 (which is OK in NM for
> low-powered stations and ONLY low-powered stations... there was a big
> discussion on that subject recently, and you should check the archives
> about it, I won't open that can of worms again), then the comms trailer in
> base will serve as a fill-in digi if needed.  We also have a portable digi
> we
> can place in the search area when necessary.  It is rarely necessary, but
> it
> does get deployed now and then.
>
> You should also set your D710 to do TEMPn-N digipeating, but I'm sure
> Bob B. will pipe in here quickly about that one.  Right now, very few
> people
> in the SAR community have their radios set up for it, so counting on the
> availability of TEMPn-N on searches is not a safe bet just yet.  But if you
> set your own truck to do TEMPn-N, then when you know you aren't reaching
> a wide with your handheld on a search, and you know you can hear your
> truck,
> you can tinker with your path to use TEMPn-N for a while to be sure of
> getting
> out.  You'd use "TEMP1-1,WIDE2-2" in that case, and as long as your truck
> can hear you you're good.
>
> One thing you should NOT do is set your truck to digipeat WIDEn-N as if it
> were permanent infrastructure.  Some folks in NMSAR did do that for a while
> and it was a terrible mistake --- it meant that ALL traffic heard by the
> incident comms trailer was getting digipeated if it had any wide hops left.
> That meant the APRS radio in the trailer was transmitting all the time, and
> desensing lots of nearby voice radios every few seconds.
>
> --
> Tom Russo    KM5VY   SAR502   DM64ux          http://www.swcp.com/~russo/
> Tijeras, NM  QRPL#1592 K2#398  SOC#236 http://kevan.org/brain.cgi?DDTNM
> "One man alone can be pretty dumb sometimes, but for real bona fide
> stupidity, there ain't nothin' can beat teamwork." - Edward Abbey
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig ****
>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig****
>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig****
>
> ** **
>
> ------------------------------
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.tapr.org/pipermail/aprssig_lists.tapr.org/attachments/20110920/c5693636/attachment.html>