[aprssig] UI-VIEW setup

[Andrew Rich]

Shot down in flames once again

Trying to configure VK4* messaging INET <---> RF

Our load is VERY low for messages.

I suspect my question is, how do you interpret "DEST" and "RECPT" in the 
igate.ini

And why does it not let you specify both ?

I could add "VK4TEC*=ALL" and just handle my car, but I would like to help 
others.

Andrew


----- Original Message ----- 
From: "Keith VE7GDH" <ve7gdh at rac.ca>
To: "TAPR APRS Mailing List" <aprssig at tapr.org>
Sent: Saturday, December 05, 2009 10:09 AM
Subject: Re: [aprssig] UI-VIEW setup


> Andrew VK4TEC wrote...
>
>> I am trying to configure UI-View to go from RF to INET
>>
>> That is no probs
>
> OK, but if it isn't a problem... ?
>
>> It is the "pass only messaging" I am having probs with.
>>
>> I can set "VK4* = DEST"...
>
> I'm sure there are lots of knowledgeable users here, but you might get
> more responses on the UI-View support list, but why don't you state what
> you are trying to do? You said above "trying to configure UI-View to go
> from RF to INET"... are you trying to gate messages to local stations,
> or perhaps gate a particular station to RF? If you are just trying to
> gate messages to local stations, why message around with messages to
> VK4* stations? I can give you all kinds of suggestions on how to do
> that, but before I invest time in that, I'll await a confirmation that
> this is what you are trying to accomplish.
>
> You weren't trying to gate ALL message to VK4 stations to RF, were you?
> I have no idea how much messaging goes on in VK land and whether it
> would create enough traffic to inundate the RF network around you.
> Perhaps you are just trying to gate messages to local stations.
>
>>  but once you use up "VK4*" you can't re-use that in the UI-View list
>>
>> Ideas ?
>
> What UI-View list? I kinda suspect you are just trying to gate messages
> to local stations, but perhaps you could say. Sorry, but if you ask a
> vague question, you will likely get a vague answer... or none at all.
>
> 73 es cul - Keith VE7GDH
> --
> "I may be lost, but I know exactly where I am!"
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.426 / Virus Database: 270.14.94/2545 - Release Date: 12/04/09 
19:34:00