[aprssig] agwpe and d700

[Ken Collins]

In message <1109291807.421e731f2710c at www.kd4rdb.com>, Wes Johnston 
<aprs at kd4rdb.com> writes
>Can anyone point me to a quick setup guide to get the kenwood d700 
>working in kiss mode with agwpe?  Or advise about the commands to go 
>from TNC PKT on front panel to kiss mode on internal TNC?

Run AGWPE. This will create a small twin antenna icon in your systray

1.      Click on that icon and select Properties.
2.      Create a New Port and setup the COM port and TNC. Use
             the TNC2 option from the TNC selection list. Click on OK.
3.      Click on the systray icon again.
4.      Select Setup Interfaces and enable Winsock TCP/IP Application
             Interface with a TCP port of 8000 and click OK.

You will now have to exit and restart AGWPE.

 From here on, every time you start AGWPE the D700 will automatically go 
into KISS mode. Conversely when you close AGWPE it will exit KISS mode.

Sounds a lot but it is very simple to do and the setup should only take 
you a couple of minutes.


-- 
Ken Collins - G4FIP
E-mail:- g4fip at tiscali.co.uk